![]() Push as a step sequencer-Maschine for its pads. I've wanted to be able to use Ableton Push and NI's Maschine interchangably. If anyone wants to help me figure out how to do that that would be awesome! Ps: I believe the original template sends visuals back to the Maschine controller itself. I know this is really nothing special but it's just my way of saying thanks to the community and all the people that put in actual hard work =P Chances are I'm just doing the job for the folks over at Presonus.j/k Customize it to your liking and feel free to share your modified versions with me. Įither way I hope anyone who uses Maschine as MIDI controller for Studio One enjoys this and gets some use out of it. With it starting at C-1 in Group A and going all the way up till G7 in Group H with no pads playing the same notes twice. While I can understand the reasoning behind starting at C with each group, I'm much more comfortable with the pads laid out sequentially the way they are in the FL Studio template. So Group A starts with C-1 (ends at D#0), Group B starts with C0 (ends D#1), Group C starts with C1 (ends at D#2) and so on. This particular template has the pads mapped out how the S1 Maschine mk1 template is with each pad group starting at C. While I've yet to write anything on it yet, S1 really is really impressive at how far they take controller mapping and how much you can do without clicking ![]() I also used the blue/light blue colorized method in the FL Studio mk2 template so that you can easily differentiate between whole notes and half notes. The only difference between this template and the template S1 had provided is that there's no pan control on this one since there's less knobs on the mk2 than the mk1. Either way I REALLY REALLY hope someone gets some use out of it.going through all 128 pads and assigning each pad's key by hand is painstakingly dreadful, not to mention if you lose count you have to start over from where you made an error. Even though there are other templates going around for it, I figured since I was a total n00b to the DAW it be best to just go with the one S1 had/hadn't made. ![]() Either way, I figured I'd make the best of it and just convert the mk1 Studio One template by hand in NI Controller Editor for use with the mk2. I was rather disappointed though when I found out that the only Maschine template included in S1 was for the mk1, especially since (to my knowledge) you can't convert a ncm file to a ncm2 file. After reading through the favorite DAW thread recently and being such a long time FL Studio user I decided that I really wanted to give Studio One a try, due to the ease of MIDI routing capabilities.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |